How to find women's shorts

To build the pattern of the shorts, you need to create pattern-based classic women's trousers. The instructions on how to build it, http://www.kakprosto.ru/kak-91888-kak-postroit-vykroyku-klassicheskih-bryuk. After she is ready, you can start modeling for future shorts.

Measure the length of the product. It may vary from knee length to mid thigh. The waist line was lower by 3-5 cm

Mark the line of the pocket on front part. Draw a diagonal line, departing 3 cm from the lateral line towards the middle and 12-15 cm down.

If you wish your shorts were a little flared and a free draw from the Darts in a straight line. Cut the part along this line and spread, and the point on the waist line must be aligned.

Build the detail of the burlap pocket. Attach a sheet of paper detail of the front and circle line entrance to the pocket. Step back from the top 2 cm to the side and from the lower 6-7 cm to the side and 2-3 cm down. These points connect smooth lines.

Make pattern belt and belt loops. The pattern of loops is a rectangle 3x5 cm zone is a rectangle with its length equal to the circumference of waist plus 6 cm and a width of 6 cm Width of the finished belt will be 2 see If you want to carve out a wider zone, respectively, increase the width of the part. It should equal the desired width of the belt multiplied by 2, plus 2cm for allowances.

Paper pattern shorts ready. Put her on the wrong side of the fabric and draw a chalk. All parts are cut out, leaving allowances for seams at 1 cm on the side of cut and the waist line. For bended form the bottom, leave 3-4 cm belt Detail and belt loops cut out without allowances (they are built into the pattern).

Burlap pocket will have plenty of lining fabric, and the area of the side seam above the entrance to the pocket from the main.