Consumption calculation of fabric, choice of style

To determine the number of required fabric easy. If width 110-150 cm (depending on size and sleeve length), enough to buy 1 length. Its measure is so – marked the beginning of the tape measure to the top of the shoulder, across the chest down to the desired length. Remember this figure, add to it 3.5 cm (1 in shoulder seam, and 2.5 on ACC bottom). So much fabric you need to purchase.

Straight – dress casual. It's not fitted, so the rear or side of the zipper to sew is not necessary, but the mandatory Darts. They can be side or go from shoulder to top of chest. Because the clasp will not make the neck big enough that it could easily remove the product. The neckline can be round, diamond, square.

How to cut a dress

Pattern a little straight dresses consists of front, back. If the model with the sleeve, is necessary and this detail. To save fabric, fold it almost in half. The width of the smaller leaf (which is top) equal to the width of the largest site in the part of the shelf (front), plus 1 cm seam.

Align the middle vertical line patterns shelves place the fold of the fabric (the fabric is folded right sides), how many pins. Novice seamstresses to better describe small-scale or soap the contours of the parts on the fabric. Those who are already familiar with this science, can cut the shelf, leaving a 1 cm seam allowances and 2.5 cm ACC tissues. Don't forget to move Darts.

Back put to the place of the bend, as well combining. If she is cutting, don't forget to leave 1 cm for seam allowance and in the middle. Attach the folded in half fabric detail sleeves. Cut right and left.

How to sew a dress

If the backrest consists of two parts, sew them in the middle. Fold back panels of shelves and right sides. Sew the side. If the fabric is knitted, silk, immediately treat the seams. If the blade will not magiritsa, you can do it after it is fully stitched dress. Close the shoulder seams.

Stitch the sleeve, fold the bottom will attrocity it. Vacate sleeves in armhole. If not, treat the armhole facing. It is processed and neck. For this fit the bias binding, you will have plenty of remnants of fabric on the diagonal. You can attach a neck, arm openings, to fabric, to outline these details and cut out the facing width 2 see it First and the main part fold right sides, make the seam width 0.5-0.7 cm, iron it. Then turn the bake on the front side, is applied to the underside of the main fabric and sew.

In the end, sew a dress, treated seams, iron the finished product.