You will need
  • a wide and shallow bowl of water, marker, kit for cold curing, the duct tape, scissors, glue TRS 2002, rubber patch, clamp, fine sandpaper, shaving brush for shaving or a soft hair brush, soap
Instruction
1
Inflatable pools are made from PVC, rubber, rubberized fabric. For each material requires its own method of repair. But first locate the puncture. For this slightly inflate the pool. Parts if not fit entirely, immerse it in water. The puncture decide on coming out of the hole puncture air bubbles. Mark discovered the puncture token.
2
If the pool is cumbersome and the use of such a method is not possible, use this method: Wet the soap using the shaving brush or a hair brush whisk foam. Apply on the surface of a well pumped to the pool. The puncture determine uzdevuma under the foam is the air bubbles. Mark the damaged area with a marker.
3
If you want to quickly and temporarily seal the damaged place, use Scotch tape. Before the sealing sacotte slightly damaged area with fine emery paper. Carefully cut the needed size piece of tape. Do not touch the sticky surface of the tape! Put the patch on the damaged area. After this temporary repair, the pool will last about a week.
To repair, use a special patch from the car kit cold curing chambers. Sacotte sandpaper the damaged area. Remove the adhesive side of the patch of the protective film. Press firmly clamp the patch to the affected area. Remove the clamp after 1 hour.
The damaged area on the rubberized fabric tape with two-component adhesive TRS 2002.