How to connect the antenna to the TV

Connect the antenna to the decoder. Typically used to receive the UHF signal antenna should be inserted into the slot on the rear panel of the decoder. Depending on the model of the device socket will be marked "Antenna" or "Ant".

If the same antenna you plan to use for broadcasting normal (analog) TV, connect using a special cable or antenna extension cable connector on rear panel Ant. out." ("Ant. out") to the antenna input of a television receiver. In the absence of the decoder such possibility of connection, use the divider signal (antenna splitter).

The next step is the connection of the decoder to the TV. The connection can be made at a low frequency using a special interface or a high frequency.

In any interface, first switch the television receiver to the corresponding video mode that the signal did not come from antenna input and relevant video input. To switch use the button on the remote control of the TV or on the front panel of the device. Usually it is denoted by "Video", "AV", "AV/TV", etc.

If your TV has multiple inputs, repeatedly press the appropriate button or select the desired mode from the menu, following the instructions to the TV.

Connect the decoder to the TV at a low frequency trigger via cable with three connectors ("tulips"). Turn one end of the cable into the decoder, the color of plug should match color of socket. The second end of the cable turn on the TV.

Connect the decoder to the power supply. If no indication check in what position is the switch on the body of the decoder (on the rear panel near the power cord). With proper decoder on the front panel you will see the corresponding indication.

Now the antenna is connected through the decoder. Configure the connection, switch your TV to the appropriate video mode. Setup can be done from the control panel via the context menu or buttons on the control panel of a television receiver.