You will need
- - flat screwdriver;
- - Phillips screwdriver;
- - water tank
Instruction
1
Drain the water through the drain hose
This is probably the fastest way to drain the water from the washing machine. To use this method will in case if in this model the drain hose is located at the bottom of the hull. Disconnect the hose from the rear wall of the washing machine and drop it on the floor after putting the water tank.
This is probably the fastest way to drain the water from the washing machine. To use this method will in case if in this model the drain hose is located at the bottom of the hull. Disconnect the hose from the rear wall of the washing machine and drop it on the floor after putting the water tank.
2
Use drain pipe
Note that the pipe for the emergency drain is not available in all models of washing machines. Usually it is located next to the filter pump, under the cap. Open the decorative panel and make sure you have the part. Gently pull the tube, remove the plug and place the prepared water tank.
Note that the pipe for the emergency drain is not available in all models of washing machines. Usually it is located next to the filter pump, under the cap. Open the decorative panel and make sure you have the part. Gently pull the tube, remove the plug and place the prepared water tank.
3
Filter pump
In most models and brands of washing machines, provided the pump filter. Typically, the filter will be in the lower part of the washing machine, on the front panel. Usually it is closed with a decorative panel or hatch.
Remove the decorative panel. In the presence of the hatch, pick up the edge using a flat screwdriver. If the filter is located under the narrow decorative panel - determine the method of installation. In the case of fastening to the locking hooks, install them vertically with a screwdriver and remove the panel. When fixing the panel with latches you need to open her top, and then carefully disconnect the latch at the bottom. If the protective panel is mounted on the screw and latches - remove it by sliding to the side.
Slightly tilt your washer back and place the prepared container under the pump filter. Make sure that the pump filter is not fixed additionally. If necessary, Unscrew the fastening screw holding the filter. Grasp the filter handle and rotate it counter-clockwise. Once the capacity is filled with water, tighten the filter and empty the container. Repeat the operation until complete draining of water from the washing machine.
In most models and brands of washing machines, provided the pump filter. Typically, the filter will be in the lower part of the washing machine, on the front panel. Usually it is closed with a decorative panel or hatch.
Remove the decorative panel. In the presence of the hatch, pick up the edge using a flat screwdriver. If the filter is located under the narrow decorative panel - determine the method of installation. In the case of fastening to the locking hooks, install them vertically with a screwdriver and remove the panel. When fixing the panel with latches you need to open her top, and then carefully disconnect the latch at the bottom. If the protective panel is mounted on the screw and latches - remove it by sliding to the side.
Slightly tilt your washer back and place the prepared container under the pump filter. Make sure that the pump filter is not fixed additionally. If necessary, Unscrew the fastening screw holding the filter. Grasp the filter handle and rotate it counter-clockwise. Once the capacity is filled with water, tighten the filter and empty the container. Repeat the operation until complete draining of water from the washing machine.
