How to make Darts

A dart consists of three parts: stem, body, and tail. Start its manufacturing with the web. From the roll of wire with a diameter of 3 mm cut a piece length of 12.5 cm Its end sharpened so that the tip embedded itself in the tree. Length of the sharpened area must not exceed 1 cm.

Mold the body of the dart. Take a wooden block, drill a hole with a diameter of 6 mm and a depth of 3.5 cm For fill you will need a lead – it can be cut into small pieces of the old cable. Fold the segments into a steel dish and melt. Pour the liquid lead in a wooden form, and then cool down with an ax split the bar. In the body of the dart drill longitudinal through hole with a diameter of 3 mm.

Fill the hole glue for metal and put the body of the dart on the web: wear from edge, 2 inches from him clip the body and leave until the glue dries.

Cut out of drawing paper or paper for watercolor blanks for the tail in the shape of isosceles triangles. The part height is 4 cm and breadth 3 cm. Cut out four blanks and bend them along the Central axis in half. Fluff glue "wings" of the parts, attach them to each other. It is important not to press them immediately, and leave the center hole. Threading the end of the dart in the hole, push the tail to the rod and hold until the glue dries.

Make a dartboard. Take a wooden Board of thickness not less than 1.5 cm cut out from it a square of side 50 cm With a compass, draw on the blank three circle with a radius of 6.35 mm ("Apple"), 107 mm (ring the trebles) and 170 mm (the ring is the "doubles"). Each ring will depart inside of 8 mm and draw a circle.

All round the field, divide it into 20 equal sectors, as shown in the figure. Sign over each segment number which represents the number of points. Acrylic paint color wedges field alternately in black and white colors (the segment with 20 points - black , 1 - white, etc.). Part of the ring above each black segment to make red and white over green. The center "bullseye" fill with red ring around it green.