You will need
- Mobile phone, charger, computer with Windows, the program Phoenix.
Download the Phoenix software from file-sharing sites on the Internet.
Rechargeable phone. In cases of impossibility of charging for the phone installed a charged battery from another phoneor charge it the battery". Extracted from phone SIM card and memory card. Plug a dead phone via cable to the computer.
Run on the computer "device Manager". To do this, right-click activate on the icon "My computer" the tab "Properties" then "Hardware" and select "device Manager".
Activate button on the mobile phone. Push and hold it for a few seconds. Repeat the procedure 3 times with an interval of 15-20 seconds.
Note in "device Manager" the emergence of new device have the same name with the model of phone. Their appearance testifies to the successful installation of the drivers.
Run the Phoenix software. When choosing the type of connection, select No connection. On the instrument panel to activate the tab "File" and choose "model Name". In the list of devices find your model of phone and confirm the selection by pressing OK.
Activate panel tab Product code. Select the required version, set the tick in front of the language selection and confirm the selection.
Activate the Firmware Update tab, note the position of the tick Dead Phone USB flashing and click on Refurbish button. The program will require the inclusion of the phone. Click on the power button of the phone and hold for 2-3 seconds, then let go. The process of flashing phone in dead mode occurs within 8-10 minutes.
At the end of the firmware of the observed message: Product flashing succeeded. Press OK and the phone turns on automatically. Disconnect the phone from cable, turn it off, install back SIM card and memory card and activate. Check the operation of all its functions.
To the question of charging take with the utmost seriousness. Half-discharged battery is not able to provide the whole cycle of flashing dead phone, which can completely ruin the telephone.