Instruction
1
Special stickers for cars you can buy in specialized stores, and the technology of their bonding is reminiscent of the technology of application of tint film on the Windows machine.
2
To put that sticker on the car, you'll need a soft cloth, a sharp hobby knife, rubber squeegee, a spray bottle with water to which is added a small amount of detergent, and dryer, which is required if you are going to stick a big sticker. If you choose the sticker size is more than half a metre in length or width, have another person assist you in its application.
3
Before you put the image on the car, wash it thoroughly and wipe with a soft cloth. Then the hood of that coat, wipe with white spirit to degrease and remove chemical contamination. To the application of the decals was good, the temperature at pasting of the car should not be below five degrees Celsius.
4
Note on the hood of the places where will be located the upper corners of the stickersto navigate and to apply it correctly and symmetrically. Mark with a marker the desired point on the hood and align them with the upper corners of the sticker, applying it as evenly as possible and gently just pre-attach the sticker without removing the substrate, to the hood to understand whether you like its location.
5
Determining the exact location of the sticker, remove the protective backing and spray water from a spray bottle the hood of the car and the adhesive surface of the sticker. Attach the sticker to the car, and then adjust its position – thanks to the water sticker is easy to move on the surface of the hood.
6
Smooth out the sticker to eliminate air bubbles. Then take a felt or rubber spatula and carefully smooth the sticker from the center to the edges. Heat the sticker in the process of gluing with hot air from a hair dryer.
7
On the uneven surfaces of the machine housing to heat the sticker and pull it, and then roll with a spatula.
Pasted the sticker again warm and dry with a Hairdryer and leave it for 15 minutes. Remove the foil, gently pulling it over the edge.
8
Spray the sticker with water from a spray bottle and apply again to get rid of remaining air bubbles. Clean soft cloth wipe the car and leave for a day in a warm and dry place.