You will need
  • - antiseptic;
  • - anesthetic (lidocaine, procaine);
  • - sterile needle or scalpel;
  • glue BF-6;
  • - means of improving microcirculation;
  • - stimulators of tissue regeneration.
Instruction
1
Remove the jewelry. A hole of 6-8 mm will be delayed independently. In that case, if you wear a tunnel or plug of larger diameter, this procedure will help you determine the elasticity of the skin. Per day, on average, the hole should be reduced by 1-2 cm If it is reduced in diameter less than 10 mm, it is likely you will need professional help.
2
Contact your ENT doctor to resolve the question about surgical way of getting rid of the defect lobe. The choice of treatment depends on the specific situation. The procedure may be limited to excision of the scar tissue around the perimeter of the tunnel and the imposition of one or two joints, whereas in complicated cases may require plastic surgery to restore the original appearance of the ear lobe.
3
If the tunnel large diameter is tightened independently, you can speed up this process so-called method of micronesica. Its essence lies in the fact that the edges of the holes are damaged in several places medical needle or a scalpel to stimulate regeneration of the skin. Before the procedure, wash your hands thoroughly with soap and water and treat them with a solution of any antiseptic. The same solution disinfect the lobe. To reduce pain spray on skin "Lidocaine spray" or apply novocaine ointment. Take a sterile needle from a syringe or a disposable scalpel and in a few places apply a notch depth of 1 mm. Grease the edges of the wound with medical glue BF-6 and connect with each other. Be careful in contact with broken skin infection will develop inflammation, which will set back the timing of tightening of the tunnel.
4
Method micronations can be replaced by short-time insertion into the tunnel jewelry, having a diameter larger than the hole itself. Preparation for the procedure and its conclusion is similar to that described above.