Instruction
1
The screen itself is a simple mechanism. First is the frame of the TV, with a rectangular frame. The parties must reach an average of 1.5-2 meters in length. The upper part of the screen can be made from conventional strips or a piece of wood. The heavier sticks (you can also use the rail).
The top and bottom of the composite screen ensure a reliable fixation in stagnant water and on a small stream.
2
The finished frame is attached to a network fabric using a sturdy thread. The thread need to be fixed at the beginning of the stick (the rack) and start to throw a cell on the thread and tie it to the stick.
It is worth to remember that the smaller the thickness of the filament mesh and other fabric, the more fish you can catch. A more efficient network of fishing line, but they are not as durable. Setae the cloth is made of braided cord or twisted rope
Each cell of a cloth tied to the edge of the spiral. The thread is threaded from top to bottom, not missing a single cell, lengthening, thereby, in a straight line. The network will operate more efficiently, the smaller the tension of the mesh and other fabric. Also the length of the thread between the top and bottom will depend directly on the height of the fishing screen.
3
A centimeter from the edge of the strips from the two sides need to make the loop knots to secure the ends of the screen and the net yarn.
4
To the bottom of assembled cloth is attached to the load. In the upper part is usually attached with fishing line float. It will be on the surface of the water and specify that caught fish. You can install the rigid float in the form of dried and painted with waterproof paint stick.
5
Fishing screen is installed in two ways: lowered on the fishing line or rope from a boat or thrown from shore. At one end of the screen tied to a long rope, with which design can easily be pulled to shore.
If you install some fishing screens, be sure to mark in any way the place where they are located, then to them it was easy to find.