You will need
  • - a viewing hole or overpass with shared or portable lighting;
  • - lifting device (winch, hoist, hoist) designed for a load not less than 300 kg.
Instruction
1
For removing the engine from the vehicle, set it on a rack or a viewing hole. Take care of the lighting of the workplace. When removing the engine, the use of hoists, winches or hoists with a capacity of at least 300 kg.
2
Open the hood, Unscrew the bolts holding it and remove it. Remove the surge tank cap, open the radiator cap and the air valves on the engine block and the heater to drain the coolant. To drain the oil from the crankcase, open the drain holes. After draining the oil supply tube and tighten. Remove the battery.
3
Disconnect the wires from the ignition coil, starter, generator, gauges, instruments, sensors, and detonation timing. Remove the radiator hoses, water pump and thermostat. Disconnect the ground wire. Remove the bolt attaching the left cushion to the engine.
4
Remove the hose of the air filter cover and filter element the air filter. Then remove the air filter housing, eliminating the ingress in the engine nuts and washers fixing it. Disconnect from the carb all the cables, linkage, fuel lines and hoses, closing the nozzles clean wipes. Disconnect the heater hoses, vacuum booster hoses and the map sensor. Disconnect the hose filter of thin clearing of fuel. Unscrew fastening of the right pillow to the engine.
5
Removing the cable lock hood, remove the trim of the grille. Disconnect the hoses to the surge tank. Remove the radiator. Gear motor for lifting eyes and pull the chain of the lifting device.
6
In the cabin of the car remove the rubber sealer from the gear lever and cap of the neck of the case. Remove the gear lever. Close the hole with a clean cloth.
7
Under the car remove the propeller shaft Assembly. The hole in the gearbox plug stopper. At the transmission, disconnect the wires and speedometer cable. Clutch slave cylinder remove the clutch housing. Disconnect the pipe receiving exhaust from the exhaust manifold and the transmission. Disconnect the mounting of the rear engine mounts to the transmission crossmember from the side members of the vehicle. Very clear the crossmember.
8
Using lifting device, remove the engine Assembly with gear box and clutch.