You will need
- - scissors;
- - iron
- - pins;
- - the tape;
- - threads;
- - sewing machine;
- - tailor's chalk.
Remove the three measurements: waist, hip and length.
Fabric measure the length of the skirt taking into account allowances for seams and hem the bottom.
Calculate the width of a panel based on the depth of sweet, which should be two widths.
Cut the fabric from edge to edge. In the same way has been second and third panels of the product.
Lay the cloth wrong side on the table and mark the line of the hips. Aside from the upper edge of the height of the hips. Add 1 cm allowance for a stitched belt.
Check the depth and width of the folds of tailor's chalk. Sweeps and proutyuzhte folds.
However on the reverse side of the cloth skirt on the side of cut. Sew the seams. Follow one of them from the bottom to the hip line, then prostrochite perpendicular to the line of joining of the edges of the folds. Sewn allowances of seams.
Keen belt to the upper cut of the skirt. Try on the product.
Excess length cut off for the upper cut of the skirt. Remove the excess width in the depth of wrinkles.
Incise the deep pleats at the rear edge neprestannoe incision. Leave a 0.5 cm uncut tissue to the point of convergence of the edges of the folds.
Keen and proutyuzhte the depth of the folds.
Lay the zipper under the edge of the cut. Pristrochite on the edge. Do the same with the second half of the zipper.
Sew the waistband.
The number of folds must equal the circumference of the hips, given extra thickness divided by the width of the folds. To skirt visually seemed to be a single entity, the joints grinding should be located in the inner part of the folds and number of folds must be a multiple of the number of panels.
When buying fabric, always add allowances for seams, hem the bottom and the seams. Consider the width of the banded zone. The total width of the fabric for sewing skirts in the crease should always be equal to three girths of your hips, plus four inches for freedom of movement. Skirt will fall in beautiful folds and have the same length, if in the middle of the back and front pieces make the cut at a depth of 1.5 cm of the Edges of the cutouts being eroded to the sides.