Advice 1: How to connect a computer to the DVR

DVRs provide convenient opportunities for surveillance of ATMs and retail properties, behavior of customers, and cashiers, as well as monitor the safety of private property and just for what is happening outside. They record video in acceptable quality and volume, then it can be viewed by connecting the DVR to the computer.
How to connect a computer to the DVR
You will need
  • computer;
  • software to the DVR;
  • switch;
  • - patch cords.
Instruction
1
To connect the DVR to the computer, you must first correctly connect all cables, and configure the operating system. Connect the DVR to a network switch, and the switch to the computerusing patch-cords. You can connect the DVR directly to the computer, bypassing the switch, however, the twisted pair must be compressed with one end in a special way.
2
Insert the software CD for the DVR drive of your computer. Install the software from disk. Normally the installation starts with Windows startup. If the CD autorun does not work, need to run independently. On the desktop, click the shortcut "My computer". Next, select the software CD and run the file called Setup.
3
Run utility of videregistrator from a shortcut on the desktop or from the corresponding menu item. Read the help on setting up the DVR. Specify a folder on your computer where to save the recording video files. Please note the file size and allocate enough space on the hard disk. Depending on the software, videos can be handled by various utilities. It is also worth considering that this will depend on image quality and file size.
4
If you only listen to this device, selecting a DVR, you should pay attention to some important features: the number of input channels, the recording speed, resolution, type of compression, possibility of connecting external hard drives and IP cameras. Do not think that the DVR is difficult to connect to the computer, just need to do things right and alternately.

Advice 2: How to connect the logger to the Internet

If you decide to use videoby the Registrar for the safety and security of your office, home or other property, sooner or later want to output the data to a computer or the Internet. It is necessary to perform a series of simple steps.
How to connect the logger to the Internet
Instruction
1
First connect the logger to an Ethernet network, ie local. To do this, use standard twisted pair and connect the device to a network switch. You can also directly connect the DVR to the network card of the computer objav wire according to the scheme "cross". Install to personal computer software that was sold together with the device for control by a computer.
2
Get a static IP address in order to connect the logger to the Internet. To do this, contact your ISP and find out if he provides such a service. If not, you will need to register with the dynamic DNS service to obtain a permanent domain name for your personal computer or laptop. Specify this information in the network settings of the recorder.
3
Set the username and password, which will be implemented by access control by the Registrar. After that you can from anywhere in the world to launch a browser and enter in the address bar the IP address or domain name of your device. After that, the computer will be prompted to install software that allows you to view the video recorder, and control its settings.
4
Check the following points if you have any problems with the connection of the data logger to the Internet or access its information. Ensure that you have saved the network settings of the device and enabled web service. Propinquity IP address Registrar.
5
To do this, log into the command line, putting cmd in the "Run" menu of "start" and write ping xxx.xxx.xxx.xxx, where x is the value of the IP address. If the logger is connected directly to the computer, then check the crimped cable, maybe the signal is missing because of this.
Is the advice useful?
Search