You will need
  • - long natural hair;
  • - 2 rack.
  • - a simple wooden table;
  • - nylon yarn the color of the hair;
  • - metal pin;
  • - 3 guitar Colca:
  • - ruler:
  • pencil;
  • - 3 coil;
  • - hand drill;
  • - a bowl of water;
  • - round disc with a diameter of 5-6 cm.
  • - thick needle.
Instruction
1
Make treebank. Attach to the table 2 vertical posts at a distance of 65-70 cm from each other. The rack can be removable. In this case, the edge of the table just clamped using a clamp. If nothing suitable at hand, just fasten to the table the same distance Reiki. They should stand strictly vertically.
Two racks, pin and the three guitar tuning pegs make treebank
2
From the top left rack, measure 5-7 cm and make a mark. Here is the first peg. Second you need to attach strictly at first, and the third under the second. The distance between the pegs is equal to the interval between the top of the stand and top. On the right front mark the spot for the pin. It should be placed strictly in front of middle peg. Attach all the necessary details. For pegs it is most convenient to make holes.
3
If nylon thread is wound on one big reel, rewind them on 3 small. Hairpiece for each thread must be at least 6 m. Coils are put on pins. Fix them so that the winding direction was the same. Pull the loose ends of the threads between the pegs and the pin and tie in a knot between the uprights, at a distance of 5 cm from the right.
4
To start the netting, take Tres strand consisting of 10-20 long hairs. Moisten it with water. Swipe the end of the section next to the node facing away from you on top of the lower thread around the middle and along the top, and bring the end to itself over the top of the thread. Swipe it away between the upper and middle threads and bring yourself into the gap between the middle and bottom. Tighten the lock, slide it to the knot and press firmly. Nodules up to each other is most convenient with a needle. You have 2 strands of different length. The short end should not be less than 4 see the Remaining strands of weaves in the same way. Sure that they were tightly pressed against each other.
5
Tres to hairpiece it is quite long. It is necessary to sew. This is done in a circle. First you make a ring, wrapped the end around Tres blanks. The hole need to wear a chignon on your own hair, tied in a ponytail. Then sew in a circle, trying to bind the turns as evenly as possible. The circle should be flat.