Instruction
1
Please note that the tappet is located between the valve tip and pushrod. Remove the engine cover of the car, immediately clean the valve crankcase ventilation special karlspreis.
2
Cap candle wells cleaning rags (cloth). Then take a screwdriver and pry her detail, which is located above the tappet. Then carefully sternite it from the tappet and not worry if the part you dumped (it is very easy to put back).
3
Remove the tappet with a pair of pliers. It should be very easy to get out.
4
Make a simple device that you need to pump, prepare the syringe and put him on a drip. To clean the head means "SHUMMA". Pour the substance into the syringe (should have foam, but then it will turn into liquid).
5
Put the opposite end of the dropper on the tappet where it has a hole. Then start to pump it, tapping the syringe to the tool ("SHUMMA") was inside the tappet. Can do several times such manipulations can then blow karlspreis. Please note that while you pump the tappet from the side of the hole to drain the liquid.
6
Perform the following step for prevention. For this position the tappet in a container filled with means of "SHUMMA". Then leave it in that position for an hour "lay", and then repeat the procedure of pumping.
7
Remember that the lifters are sealed parts, so the oil in it, you fill fail. Therefore, repeat the bleeding procedure not only means "SHUMMA" and butter. Then put the tappet in a small container filled with oil. Then take him out and bleed again.