How to sew on a loop

To start sew button. Because the only way it will become clear how big the loop needs to be done. Take a suitable thread – make sure it matched perfectly to the product color. Thread for making stitches needs to be quite thick and durable.

Pass the thread into the needle, then tie the two ends of the thread. To do a loop you need a thread in two additions, so it would be more durable. Carefully measure so that the eyelet is positioned exactly. Take a needle and thread and sew two stitches across the width of the future loop. These stitches will become the basis for pigtails.

Around the stitches of the Foundation begin to gradually tighten the loop, one after the other. To do this, start the thread of the air loop and stretch it up through the loop, which turned out to be. Thus, you have gradually formed a pigtail. Continue to weave braid needed to the end air loop.

When the tail is completely woven, carefully secure the thread. On the fold of the fabric pass the needle two small stitch in the opposite direction. Fixing the thread, carefully cut off the ends. Loop ready.

If you need to hang Drapes, curtains or other products, you can also use office paper clips. However, such loops are only suitable for cornice, which covers the top of the curtains. Otherwise, the clip will look unsightly.

To make such loops, first measure a uniform distance from one loop to the other across the width of the curtains. Point where you will see the loops, you can assign chalk. Next, take a paperclip, unfold it to form the likeness of the letter S, and thread one end for a pre-designated place. Support the lower part of a bent paper clip. Top clips attach the curtains to the eaves.