You will need
- sheet of newspaper
Instruction
1
Take one sheet of newspaper. Usually it's already folded in half, that is has a fold in which the paper is rolled with the production of the printing. Place a folded in half sheet with a fold line horizontally and further away from yourself.
2
Right and left upper corners of the head and fold at right angles symmetrically to the center, about a third of the width of the newspaper. Formed the likeness of a trapezoid.
3
Loose the top layer of the bottom edge of the fold in the upward direction to evenly wrap it twice. For the first time in half to the bottom formed from the previous bend angles. The second is to repeat the inversion to the same value even higher. The resulting strip will overlap the corner folds. The structure itself will resemble a stack of paper boat.
4
Without changing the benchmark top-bottom, flip the newspaper to the other side. Thus, swapped only the right and left side.
5
Fold the left and right strips, each about a sixth of the width so as to form vertical parallel fold lines.
6
The lower edge of the horizontal roll 2 times myself. First half, but in the process of the second inversion attach the first limb of this step and place it over the valve pockets from these two inversions in the third step. Assembly is completed.
7
Give volume to the cap, and put it on. Step-by-step scheme of folding of the caps is shown in Fig.
