Instruction
1
To inflate balls for simulation use only manual piston pump. Take the ball and stretch it in length, and then put his hole on the tip of the pump and begin to inflate evenly, leaving a small tail with a length up to 8 cm, so that the ball was easier to twist in the future. The tip of the ball tie a knot.
2
Starting to twist any figure, do of lay always in one direction only and hold them with your fingers to secure.
3
Start to create balls of figures, starting with the most simple. To twist the dogs take one long ball and make the distance 5 cm from the start of ball one strand. Hold it with your fingers, make a 6 cm from the first lay a second, and then the same distance away in third.
4
The first and third strands loop together to get the muzzle of the dog. Back 7 cm from the last twist, loop the ball again. Back 7-8 cm and twist the two front legs, and then loop them with the previous stranding under the dog's neck.
5
Make another twist, and then repeat the process of creating legs, pinning them rear. Thus, your dog appeared front and hind legs. The rest of the balloon clip to the dog got a tail.
6
You can also make out of ball for modeling a flower, inflating it fully. Release of the ball some air and connect it into a ring, tying a single ponytail with the other. Fold the balloon in half and loop it in the center, and then divide the resulting figure into three equal pieces.
7
The resulting figure of the fold in the shape of the letter Z. Loop between the four strands, to get a flower of six petals. Between the petals push the inflated green balloon to form a stem.