You will need
- - speakers
- - soldering iron;
- - solder;
- - the transaction of the required type and cross-section;
- - screwdriver;
- - wrench set
Unplug the car before starting work, to avoid short-circuit. To do this, disconnect the negative terminal from the battery. Carefully read the instructions and recommendations that are attached to the speakers. Don't forget to purchase the wiring. In some configurations already present audiopreparation, however, laid a wire can be somewhat different from the desired cross section, which significantly affect the durability of the speakers and the quality of the reproduced sound.
Select the location where you will install the speakers. Usually they have in the doors and rear shelf, which because of this has received the name acoustic. If the door trim already has the grooves for installation, it is necessary to remove the protective panel and attach speakers.
Fabricate catwalks, if space for speakers in your configuration there is no. Podium is a kind of adapter that allows you to set the speaker so that it looked aesthetically pleasing on the background of the door trim panel. For the manufacture of catwalks, use a rubberized plastic or plywood. Brittle plastic will emit from the unpleasant vibration noise. Repeatedly do the fitting of the workpiece to minimize the risk to ruin the material. Ready podium attach using screws, pre-brushing the edges that are adjacent to the hull with sealant.
Solder the leads to the speaker. In places, adhesions glue the pieces of colored electrical tape. Now you need to carefully lay out the wiring. It is necessary to bring the head unit, usually located in the Central part of the torpedo. On some models this requires partially disassemble the lower part.
Run the wires from the door through special technical hole. To do this, take the line of medium hardness, attach it to the end of the wire. Push the line inside the door and thread through the hole, then insert it in a special protective corrugated tube and get in the car. Gently pull on the fishing line itself, until, until the end with the wires. After that, move the wiring to the back of the radio. Carefully fasten each wire for its entire length. In open places disguise it. Connect to the radio and verify the operation.
Carefully strip the wires accidentally damage it.