How to configure satellite Sirius

Install the wall mount the antenna on a vertical surface at an angle is strictly 90 degrees. Secure all points provided by bolts. Install a Central Converter and multifidi on the Central arc of the antenna. First, set up a multifeed. On the arc of the antenna put on the mounting strip, pull loose her bolt-nut. Install the Converter and turn it on 100 counterclockwise (1 step = 5 degrees).

To configure the antenna for the Sirius install for the arc center of the third Converter, rotate it to 10-15 degrees. Tighten all fasteners completely. Prepare three pieces of wire a small length, strip them, screw the F-connectors, connect them to the Converter, fit the protective covers. Install the antenna on the wall mount. For the possibility of its rotation, tighten the retaining nut until the end.

Install a Central satellite, to configure the antenna for Sirius. For this wire from the Converter plug to the input 1 of the DiSEqC switch. From its output, connect the cable to the input of the receiver (tuner), set the equipment on a satellite Sirius. To do this, connect the tuner (receiver) to the TV, perform the setup according to the instructions. In the main menu of the receiver to select "antenna Setup", set the frequency to "Manual search" 11,766 GHz, horizontal polarization "H" and the value of the flow velocity 27500 SR.

Adjust the signal from the satellite. To do this, select the corresponding menu, focus on the scale of "Quality". Place the antenna vertically, turn it very slowly in different directions to achieve the appearance of the signal. Once you have a signal, achieve its maximum value.

Next, turn on the mode "Scanning" to determine which satellite you have set up your antenna. If everything is correct, the screen will display a list of channels, respectively, of the satellite. Then strongly tighten all the nuts of the antenna, tighten them, but monitor the signal, as it can go.