Preparatory work
To connect the DVR and hide the wire, you will need to purchase USB charger for cigarette lighter and wire that is suitable for your device, that is prepare for the process. For example, the mini USB from 3 to 5 meters. It is recommended to buy 5 meters or more below the material was stock. The cost of the tools needed will be a maximum of 400 rubles. If the driver decided to use a cigarette lighter splitter for solving the issue price will be in the range of 1500 rubles.
Begin to remove the wire
To do this, under the covering of the roof at the windshield is a wire and extends to the right front. If the wire stretches across the dash, somewhere between windshield and dashboard. If you select the option from the roof, it is necessary to carefully bend the rubber band on the door and slip it under the wire. There is enough space to fit this slim cord.
Then using a screwdriver, slightly turn down the corner of the torpedoes and pass the wire down behind the glove box. In the right corner of the windshield there is a gap between the torpedo and the wind, it just need to expand a little. Then lower the glove box how to replace the filter and attach the wire to the clips at the end of installation in two places to the body panel.
After this work is done the wire from the torpedo needs to go directly to the cigarette lighter. To completely get rid of the wire, you can buy a cigarette lighter splitter, designed for two or three device, and the inside of the torpedo to connect the wires to the cigarette lighter.
Use the splitter
Purchased the device is connected to the outlet on the front console. The splitter is in the passenger seat, so he will bring a minimum of inconvenience, especially if the driver often travels alone. To hide the wire, removed the padding on the right strut and they laid there.
Devices are fixed behind the mirror and the wires run under the headliner, upholstery and glass you can stretch them without removing. Further, the cord is held on the rack down and goes under the panel in the corner at the junction of the glass panel and posts.
If you have excess wire, they hit the road and left there. The splitter is mounted on the right side on the plastic with an industrial adhesive tape. Before doing this the surface must be degreased. After completion of the work in the salon there will be no extra wires!