How to make a hair barrette "bow" with their hands

Cut from wide satin ribbon in a piece that is 2 times the size of the future bow. Then from the double-sided tape should be cut two narrow strips. Glue them to the edges of the tape, and then lock her in the ring. Similarly, make another ring of the wide belt.

Then take the two rings and put one on another so that between them the side was not less than fifteen inches. The place of fastening rings must be in the middle of the bow.

Take the thread and use it to fasten the ring of satin ribbon down the middle.

Further, the course is a ribbon of medium width. Cut off from her strip. You need to bend so that it forms a loop, the ends of which crossed each other under an angle of 90 degrees. The inner side of the resulting loop should be pressed to the point of intersection of the ends of the satin ribbon and fix exactly in the middle using thread.

Now we need to connect with each other bows of wide and medium strips, and then glue them with the glue gun.

From the narrow satin ribbon cut off a small strip. With it we will close and we can decorate the center of the bow. This ring can be mounted as a glue gun and thread to sew on the reverse side.

Decorate the barrette. This requires narrow satin ribbon cut stripe, which is exactly twice as long as the base of the pins. Glue on the Scotch tape.

Begin to hang the hairpin on the inside, and then move on to external. Remember that on the outside need to paste not only the hairpin but also all of its nooks and crannies.

It only remains to glue the barrette to our crafts. Do this with a glue gun. Barrette "bow" ready!