How to attach shoulder straps

Positioning the shoulder straps need to straight edge and sprocket were from the shoulder, not the head. They are attached along the shoulder seam and the top edge of the ring must withdraw from it by 10 mm. otherwise the shoulder strap will hang backward or forward. The short edge of the ring should be located at the level of the seam that attaches the sleeve. Logo buttons on the pursuit shall be turned in to the upper part of the neck, and the lower to the hand.

There are two types of cuts: soft, which are sewn and hard that fasten. What straps need to attach depends on the garment to which they are attached.

Sew the shoulder straps are attached to clothing using yarn and needles. Pre-fasten the shoulder straps with the aid of needles or pins, so it does not move out when sewing. It is important that the seam was not visible on the pursuit, and preferably on the wrong side of the garment. To do this, pass the needle thread folded in half so that one side hung two of the tip, and the other was a loop. Pull the needle from the wrong side of the garment, but do not pull it through. In the resulting loop and pull the thread the needle – you get a mount without knot. Next, a neat small stitches sew the shoulder straps, catching one or two threads of clothing and overhead and not getting out on its upper side. Try hard not to steal the thread, otherwise the clothes will wrinkle.

Hard straps are attached to clothes by using a zipper. Flip the shoulder straps and take the tape that runs along the bottom. Put it in a special loop on clothing. Then insert the shoulder strap button and pull her foot through openings in the clothing. Secure the button in several ways. You can just insert a small piece of match or toothpick, you can use a safety pin, thread and needle, paper clip or a special brace. Importantly, the mount was robust and don't scratch your shoulder or shirt.