You will need
- - Acetic acid (70%) - 1 tsp.;
- - potassium permanganate is on the tip of a knife;
- - solution of hydrogen peroxide;
- - a thin brush or cotton swab;
- - iron
- - a sheet of blank paper.
Instruction
1
For the preparation of destaining fluid resistant take a small clean container, for example, a stack.
2
Pour gently into a pile of acetic acid. In order to avoid chemical burn if suddenly a drop of this fluid gets on your skin, wear rubber gloves or medical gloves.
3
In a bowl with the vinegar, add the potassium permanganate and stir the solution until complete dissolution of crystals.
4
Under the sheet with which you want to withdraw blot, made with gel pen, or the wrong stamp, you must put a clean sheet of thick white paper.
5
Take the thin brush with very soft bristles. Swirl the brush in the liquid prepared in advance and very carefully drive it on the label to complete her disappearance.
6
The paper is in place of removing ink fromThanet brownish. Get the stain from the mixture of acetic acid and of potassium permanganate by simply wiping it with a cotton swab dipped in a solution of hydrogen peroxide. Hydrogen peroxide can be purchased at any pharmacy.
7
Under the sheet, treated with hydrogen peroxide, put a soft cloth. On the matter put a sheet of clean white paper, and then iron with a warm iron the top of the page, where it was still wet. If the sole of the iron is not clean enough, or the surface has scratches and rough spots, then wet the sheet you need to put another clean, dry white sheet and ironed the page is already using it.
8
To remove traces of gel ink with thick paper, use the same solution that was described earlier, but instead of a brush head sharpened on one end a match, and screw on a small piece of fleece. Make several of these cotton swabs, as they quickly deteriorate. Dip the cotton swab into the solution and draw it on the blot. The subsequent operations are the same as described in method, suitable for processing thin sheet of paper.
