You will need
  • NTV satellite dish,
  • instructions for its operation,
  • TV,
  • receiver.
Instruction
1
Put NTV-plate in accordance with the azimuth and the angle of its future location. Guided by the compass. Using the manual, connect the lead from the heater cable to the antenna. The so-called "cutting" the F-connector is the standard way:

- remove the cable insulation about 1.5 cm, without damaging the shielding braid;

- position it along the cable and then neatly laid out the foil along the braid;

- remove the layer of inner insulation 1 cm, twisting the connector until it stops. The Central conductor should "bite" to his projection of the connector was not more than 2mm.
2
Connect the digital receiver to the TV (following the instructions for its use). Then turn on TV and choose any popular TV channel, RTR, NTV, etc. slowly move the mirror of the satellite antenna in different planes (horizontal or vertical) around the proposed location of the satellite. As a result on your TV screen the image should appear. Keep in mind that after each rotation by 1 degree you need to wait 3-5 seconds (during this time, the signal comes from the antenna to the "box").
3
In the menu of the satellite receiver to select "received signal Level". It needs to be activated. Maximum values of received signal level to achieve a smooth motion of the mirror antenna in two planes, vertical and horizontal. It is important to remember that the signal level may largely determine the weather conditions. Dense rain, snow or even clouds can contribute both to lower quality, and even to the complete disappearance of the image.
4
Before comfortable to lie down on the sofa and enjoy the features of multi-channel TV, tighten the adjusting nut. Perform the operation in parallel by controlling the signal level. Then insert the card "NTV-Plus" satellite receiver according to the instructions and invite close family viewing.