Prepare all the materials and tools for the job. Remember that when welding, you should observe certain safety - it is necessary to work only with gloves and a special mask, and also away from dry boards and grass.
Start from the top and bottom of the canvas to which you want to weld a loop, about 20-25 cm and mark the measured distance construction pencil.
Miss hinges with grease, so that when welding the halves of the loops are not caked. Put under each of the loops at the edges for match. This should be done in order to after all welding a door does not eating.
Ruskinite the gate leaf to the closed position ready doors was right, that is, line up the two folds on their door.
Tack weld a little loop. In this case you first need to weld the bottom half of the part. Attention! Using the welder for the first time, you should know that to weld the loop should be bottom-up, small horizontal movements of the electrode.
Rackline after welding the first weld gate and check the correct opening and closing. Brew loop finally, if the previous steps by opening and closing does not cause you doubt.
Remove the frame from the hinges, RUB well again with grease and put into place. Treat the welds with a grinding machine and paint their own masterpiece. Your design needs to quickly and easily open and close with the flick of the wrist.
Attention! If the weld you produce without assistance in an upright position will perform them difficult. You can make work, privativa gates on earth, however, the quality of such work may not be flawless.