You will need
  • Board;
  • - sheets of plywood;
  • - oil paint;
  • - white;
  • - nails;
  • - screws.
Instruction
1
For the manufacture of boats prepare materials seven pine boards 15-20 mm thick, 300 mm wide and 5 m long. These boards will need to trim the hull of the boat. Also prepare three pine boards 4 m long, 300 mm wide and 50 mm thick pine Board 30х200 mm, 2 m length and two plywood sheet of thickness up to 5 mm. For filling joints you'll need pounds of oil paint, as well as three kilos of white in linseed oil. For fastening parts of the boat, prepare 1.5 kg of nails, a length of 5 cm and 1 kg of screws of the same length.
2
Start to build that boat with the manufacture of the frames. Frames must rise above the level of side 200 mm. After the frames make a stem and transom, install them on the keel plank, whose length is 4 m and cross-section 50х20 mm, with nails. Nail benches between frames.
3
Installation to the side boards, attach the top side of the frames, stem and transom. Neustanovena Board clear when the work is finished, and in the end cutting the extra edges of the frames – 200 mm protruding above the stern. The bottom side of a Board nail.
4
The keel Board and tear the nail instead of the Board, which is the bottom of the boat. Secure the boat on the top side of the Board. In the joints of the planks of the bottom three fasten the keel to the joints were sealed.
5
Prokonopatit the joints between the boards, tow moistened in linseed oil and then sand the joints with sandpaper. In the bow of the boat make of plywood in the trunk for things. If you catch a fish under the middle bench set live well.
6
Paint the boat inside and outside with oil paint on two or three layers. Manufacture of prepared boards, two paddles. The boat is ready.