You will need
  • - screwdriver;
  • - soldering iron;
  • construction Hairdryer;
  • - finishing material (e.g. leather);
  • - filler for plastics;
  • - a primer on plastic;
  • - spatula;
  • glue;
  • - brush for applying glue.
Instruction
1
Remove the casing facing the steering shaft, the flap. Remove the protective cladding on both speakers, pressing the plastic holders. Unscrew the bolts securing the shelf and the body of the glove box. Unscrew the nut of the speedometer. From the dashboard, pull out the cable of the counter.
2
Remove the upper shell. Remove the through openings of the glove compartment and flap 4 nuts fastening the top of the instrument panel and 2 screws bottom mounting, remove the cover and insert. Disconnect the negative terminal from the battery and disconnect the devices from the electrical circuit.
3
Remove the instruments and check that there are no cracks or chips. Inspect connections and contacts. Restore them when needed using a soldering iron.
4
Rinse the surface of the torpedo with soap and water or solvent. Heat construction dryer, remove all burrs.
5
Repair cuts and defects on the surface with a spatula and filler for plastics. Before applying sealers to treat the surface with special primer.
6
Start pasting from the highest place of the torpedo - visor. Apply glue to the visor and the inner surface of the chosen finishing material, distributing it evenly with a brush.
7
Glue the material to the surface of the visor. Warm covered plot torpedoes a Hairdryer to improve the fixation. This should be done very carefully so as not to damage the material.
8
Glue on this principle the entire surface of the torpedo. If you want to stretch the leather, heat it with a Hairdryer. Smooth it to the surface with a spatula (nicked corners) to remove the creases, and then again heat for fixing glue. Cut off any excess material. The Assembly of the torpedo are produced in reverse order.