How to plug the hole

Small holes type Shcherbina or hole from a nail embedded so: first on a hole with a spatula to apply the putty, then use the spatula to removed the excess. After drying putty (several hours) the treated area is cleaned with sandpaper, and then brush it with whisked the dust. At the end of the work spot is filled.

Large hole. Removed excess plaster. This is a knife that should clear the hole from the broken plaster, and then align the edges. Then the hole is filled with crumpled newspaper and the top is covered with gypsum plaster. All remaining voids are filled with facial filler. This filler can be applied to a section of the wall adjacent to the hole. Then the treated area is left alone at night, so it finally dried out.

In the morning filled the place treated with sandpaper until you are level with the wall plane. Then the repaired area is painted with same paint which was painted over the entire wall.

With huge holes the situation is quite different. We need to act thoroughly. First, you perform the actions described in the second step. Then take the plaster, which is glued into the hole, covering the area completely. Pleats spread with a knife.

Further, the adhesive tape is covered with a thin layer of solid fillers, in order that the surface of the plaster was slightly covered. To make the patch more durable you can stick another layer of plaster filler, although is often not required. If you plan to stick a plaster in two layers, the second layer is glued across the first and only filler. Again the surface is left overnight in order to dry out plaster.

In the morning the place treated with sandpaper without pressing, so as not to "expose" a layer of plaster. Then whisked the dust and the repaired section of the wall is painted in tone with the entire wall.