You will need
  • - Vibroplast;
  • - polyurethane foam;
  • - screwdriver;
  • construction Hairdryer;
  • - primer;
  • - solvent;
  • - anti-corrosion agent;
  • brush;
  • - spatula.
Instruction
1
Completely disassemble the car, remove the intervening wiring. Remove the trim from the doors, the ceiling and lining the sidewalls of the rear seats and the rear wheel arches.
2
Clean the seat corrosion. Solvent degrease all surfaces. Prime and paint where you remove rust. Treat the interior rust inhibitor. Fill all voids in the body of the car foam. Also use it to seal all the corners of the cavity threshold.
3
Stick in the cabin of the car and on the door of the sheets of Vibroplast, pre-cut templates. This material is adhesive, so the adhesive in this case is not required. Heat Vibroplast construction dryer, if required by the instruction. Some species do not need to be warmed up during the installation. Carefully apply the glued leaves, removing air bubbles.
4
Look closely at the mechanisms of power Windows and door locks traction that can touch and rattle when riding. In this case it is possible to isolate them from each other using foam. To do this, simply put the material on one of the contacting parts.
5
Apply double-sided tape for fixing decorative plastic covers when installing the trim panel on the door of the car.
6
Identify loose plastic equipment in the cabin. Carefully fasten the screws and nuts, placing them, if necessary, on rubber or foam pads. View thus the whole interior of the car during its Assembly.
7
Purchase and install on the car engine special protective shield, which will improve the soundproofing of the cabin.