You will need
  • hose;
  • - capacity;
  • keys;
  • - the anode;
  • knife;
  • - cleaning chemical.
Instruction
1
Unplug the heater, then remove the cover located in the lower part of the heater, and disconnect the wires. Be sure to shut off water to the apartment.
2
After this drain the water from the water tank: on the drain valve, push the hose diameter must match the diameter of the valve. The opposite end of the hose in the tub or toilet. Open the valve and the pipe to the cold water supply (the draining process takes about half an hour).
3
Located on the bottom of the boiler and its electrical part. Substitute a water heater is a bowl or other container and remove the bolts located at the bottom of the boiler (usually six units). Don't worry if you remove the bolts will not immediately: several attempts and achieve results.
4
Remove the water heater, for convenience, turn it over and remove the heater. To pull out the heater, grasp the electrical part of the boiler and remove it from the tank. Be careful: do not damage the rubber gasket.
5
Near the Heater is the anode. If the magnesium anode is destroyed, in its place may remain only a pin. Find an old anode, or what is left of it, and Unscrew it.
6
Screw the cleaned heater, and next to it install a new anode. Then assemble an electric water heater. In this case, pay special attention to the integrity of Tenevoi strip and the insulation of electrical elements.