You will need
- - spray gun;
- - paint;
- - primer;
- - duct tape and newspaper;
- - sandpaper;
- - degreaser;
- - rust Converter;
- - putty.
Carefully apply on rusted area using a drill. Use the nozzle attachment metal grinding wheel. Remove the rust to metal. Degrease and treat the Converter of rust , cleaned the corrosion spots. Be careful, the Converter contains acid. For safety wear gloves, goggles and a respirator – this protects you from flying dust, rust and paint. Try to keep the Converter did not get on skin or in eyes. If this has occurred, immediately flush affected area with water and consult a doctor.
Rinse with water the treated area to the back of the car, degrease again and zashpaklyuyte. After drying putty gently power trowel it using sandpaper wrapped on a wooden block. Provide treatment very carefully, slowly. How you do this depends on the form the repair area in the future.
Remove the dust, which was formed from putty. Better to do it with a heavily soaked in water cloth. Dry.
Start painting. Apply several paint layers, each after drying of the previous. Use the spray gun. So as not to stain those places that not need to paint, tape, attach on the car the newspaper, cut out a hole the right size. Watch out to avoid streaks. Wait a day and remove the paper. If necessary, touch up the edges of the patches. Wash your car in 48 hours after the last touch-up. If you are confident in your abilities, leave painting to the professionals.
To further rust again, try to keep the car clean, avoiding dirt traps. Regularly wash the car, carefully drying it after the procedure. Periodically inspect the body – the smallest traces of rust is easier to remove than large ones.