How to make a mosquito net

Make the measurement Windows, just open the window and measure with a tape the flap part of the frame from the inside. Note that the mosquito mesh must be done at least 30 mm more in height and 40 mm in width, so that it was overlapping. For example, for window sizes 1200х400 mm make the grid dimensions 1230х440 mm.

Take the aluminum profiles and cut blanks of the desired length. Note the perpendicularity of the cuts, all the ends of vieraita by means of a square, otherwise the finished mesh to get distorted. In order to calculate the length of each element, subtract from the total length (or width) of 60 mm Transom (the crossbar) do 55 mm shorter than the total width.

Grab the corner connectors and using a hammer or mallet assemble a rectangular frame. See to it that the groove for the rubber cord on the rails coincided with the groove of the corners.

Beat in the ends of the mullion latch for fastening (T-terminal) and connect it to the frame in the middle. Note the orientation of the T-terminals in the end of the cord grooves must match the grooves on the frame.

Cut out two pieces of mesh on the upper and lower half, each side will provide a margin of at least 4 cm Stretch mesh on the frame, pressing it into the groove with the cord. Ask your assistant to pull the mesh and ensure that it does not shift. Trim the excess mesh with a knife, leaving a small allowance to the edges of the frame sides (in case the frame will SAG and will not close the gap tight).

Insert the handle in the center to a homemade mosquito mesh can be easily installed and removed from the window. Note that the handle must be directed inside the frame.

Install the mounting hooks from the outside of the window frame to secure the mesh. First, screw the screws bottom mounting with bottom shelves, then the top – so they kept the design only the tips of long shelves (3-4 mm).