You will need
  • - Plastic panels;
  • - Wooden slats and beams;
  • - The screws and dowels;
  • - Carnations for the panels;
  • - Impregnation against fungus;
  • Primer for wet areas;
  • - Brush;
  • - Spatula;
  • - The perforator;
  • - Hammer;
  • - Hacksaw;
  • - New mixer;
  • - Laminated hardboard;
  • - Linoleum.
Instruction
1
Take a sheet of paper and calculate what number of plastic panels for ceiling and walls you need. The dimensions of the panels look in the store or on the websites of the manufacturers. Decide on the amount of timber for the lath. Primer buy in concentrate - it is diluted with ordinary water and economically expended.
2
Think about faucets. The distance between bath and sink allows you to install a single mixer. Don't skimp. Buy immediately good, from a reputable manufacturer than you will suffer with dripping taps.
3
If you do not plan to change the plumbing, then close the tub and sink with newspaper and tape in order not to hit the enamel.
4
Clean the ceiling from the previous whitewashing or painting. Razmeshivaya water chalk or latex layer, scrape it with a spatula. Because the ceiling will have panels, just enough to remove swollen or loose.
5
Detach the wall from the old cover. If the walls have been painted, strip the damaged and crumbling. If the walls were already old, sometimes repulsed tile, remove it with a drill with a special nozzle. Try to beat the hardened tile adhesive off the walls.
6
Treat the ceiling and walls special purchase antifungal composition. Dry thoroughly. Then RUB all surfaces with a coating of deep penetration for wet areas.
7
Make a crate on the walls and ceiling of plastic panels. The distance between the slats should be no more than 60 cm In places where the wall curves, place extra padding under the bars. Check all plumb and level. Immediately lay the wooden slats in those places where it will be attached to the faucet, and hooks for heavy towels.
8
Paint mascara on all the wooden slats and bars with primer. Dry and cover them with another layer.
9
Install plastic panels on the ceiling and walls. Panels are easily sawn with a hacksaw. Carnation panel score only vertically, the plastic is not cracked.
10
The joints between the walls and the ceiling decorate the foam moldings.
11
Screw the mixer to the panels in the location where you placed the wooden block. Attach hooks for towels. Between bath and panels glue plastic border so that the water would not flow.
12
On the floor lay a piece of suitable size and color of linoleum. Decorate warm fluffy rug.
13
Restore the enamel in the tub with a special purchase funds, or put acrylic liner.
14
Bath screens you can buy, but you can make one yourself from a piece of laminated hardboard.