How to remove air from the cooling system of Viburnum

Put the car on a lift so that during the upward movement rose only to her front.

Block rear wheels with improvised means or with special stoppers. Carefully inspect the position of the front wheels of the car. They should be locked in a safe position. Unscrew the cap of the expansion barrel.

Start the car. Press the gas pedal until the until the temperature increases to a critical level. After turning on the fan continue to podrazumevati for some time. If the tube is not gone, proceed to the next step.

Remove the plastic screen of the engine. The fact there are no screws, only pins with rubber seals, from which it is removed by a simple upward movement. Do not apply excessive force. Loosen the clamp with a screwdriver. On fitting of heating of throttle knot locate the two tubes. Remove one of them (it does not matter what kind).

Remove the surge tank cap. Cover the neck of the barrel with a clean cloth, blow into the expansion tank. Repeat the process until the moment of off-hook does not pour antifreeze. If the blow tank does not work, close the cover back and reinstall the throttle tube site. Again warm up the engine. After some time switch off the ignition.

Do not remove the surge tank cap again remove the tube heating. Wait until out of the tube under pressure will be antifreeze. Put the tube on the nozzle of heating of throttle knot and tighten the clamp. Install plastic engine screen plastic screen in place.