Instruction
1
Motor windings connect in the traditional way - with a triangle or a star, depending on whether the output voltage of the generator you wish to receive. In both cases, it will be three phase. The motor is dual voltage (through fraction - fewer of them corresponds to the voltage between any two phases when enabled, a triangle, and more - turning star.
2
Take three non-polar capacitor with a capacitance of about 20 microfarads. They in any case should not be electrolytic - even a non-polar capacitors of this type are not suitable. Their rated voltage should be not less than 500 V. make Sure, using a DC voltmeter, they are discharged, if necessary discharge to a conventional incandescent lamp.
3
Connect the capacitors as follows:
the first is between phases A and B;

- the second - between phases B and C;

- third - between phases A and C.
4
After the motor and capacitor install three-phase machine which allows to disconnect the generator from the load. If it to untwist when the connected load, it may not begin to produce voltage.
5
Connect the load after the machine, the machine itself off. Loosen the engine up to rated speed, wait a few seconds, then turn on the machine. Voltage goes to the load.
6
Do not use in conjunction with a homemade asynchronous generator ferroresonance stabilizers, because the frequency of voltage produced by them is unstable. Don't feed him loads sensitive to changes in voltage and frequency.
7
If you want to install a generator on a stationary bike, as well as to improve its electrical part, use the tips from the page whose address is given below.