You will need
  • Soldering iron, one or two connector RCA (Tulip), one TRS connector 3.5 mm (mini-Jack), two-wire shielded cable, the knife.
Instruction
1
Most modern TVs in addition to HDMI, S-Video and SCART, I have the RCA connectors, which in the vernacular is called "tulips". It is through them we will transmit sound from the computer to the TV. If your TV supports stereo sound, then these connectors will need two (red and white connectors on the TV), if mono, then only one (the white connector).
2
The computer audio output may be on the motherboard or separate sound card if it is installed. Typically the nest has a light green color. If the sound from the motherboard you have divorced on the front panel of the chassis, this slot is at the front, otherwise the back. Connected to TRS connector 3.5 mm, which is commonly called the "mini Jack".
3
Take the cable of the necessary length with a knife and clean it from both sides. Proceed carefully, take care not to damage the wire when the insulation is cut. The shield gather to one side and twist into a pigtail. For what would a brazing process developed better leads must be tinned with stinging. Disassemble mini-Jack and solder the shield to the large lobe, and two wires to the two small petals. Now assemble the connector back.
4
It is time to engage the other end of the cable. If you need a mono signal, then solder to the exterior of the "Tulip" screen, and the center contact both signal wires. Before you solder the connector to the wire, don't forget to put on it Unscrew the part of the connector. If you have a stereo sound, then the screen should be divided into two parts and solder each part to external contact "tulips". To the Central contacts of both "tulips" is soldered on one signal wire. Build the connectors and connect the cable to the respective connectors on the TV and the computer. Now the sound from the computer will be heard through the television speakers.