You will need
  • User's manual alarm
  • Two remote alarm
It may happen that your attempts to remove the car from protection with remote alarm will have no reaction. Serena "you gonna croak," turn signals not to blink and, most importantly, will not open door locks. The reasons for such a reaction, or rather,its absence may be several:
1. The battery in the remote or the remote is faulty

2. Interference on communication

3. Got the battery in the car

4. Faulty alarm unit
Look for fault in the system it is necessary by process of elimination. Start with the key FOB. Change the battery in the remote. If you have a control panel with LCD display, there will be clearly visible battery power and periodically will be issued a warning beep. If the battery you have changed, and the machine on signal is not responsive, take your second key chain ( included the alarm always two) and try to disarm them. If this happens, then the first FOB is faulty or it needs to be re-programmed.
If both the key FOB off the car with protection can't otkroite the car door key must scream of the siren. Find the Valet switch click off. The location of this button, you have to show in the center of the installation necessary!. Open the manual to the alarm system, "Emergency removal of the alarm without the remote". And the user doing the manipulation with the ignition and Valet switch. If you did everything correctly, the siren screaming will stop and the alarm will respond to the remote.
If when you turn the ignition on the panel of devices lights up weakly lamp or illuminated sign "low battery, the car won't start, the siren constantly screaming, it means the car battery is dead. To disable the siren, remove the battery, if required. If the siren is offline, disable it with a key. Remove the battery and charge it, or lit wires from another machine. Typically, such a malfunction alarm happens in extreme cold. If you have a weak or old battery, do not place the machine in security for a long time at low temperatures. After removing the battery from slipping alarm settings and remote have to be reprogrammed.
If all vysheperechislennyh steps do not help, look for the alarm unit under the dashboard, disconnect the connectors from all the wires. Try to start the car. If it won't start, so made a lock: ignition, starter or fuel pump. To turn them off find the wires coming from the alarm unit to the standard wiring harness of the car. If the regular wire harness raskushen and attached the wires from the alarm it lock. Otsoedinaut the alarm wires and the ends of regular wires connect together. If the lock is done one and you correctly found it, the machine will start.