You will need
  • Trouser braid, duct tape, sewing supplies.
Instruction
1
To start, determine the length of the pants, while wearing them on man. If the owner is wearing pants with a belt, the belt will want to wear. Pant length is measured in two ways: with shoes and without shoes. It is better to resolve with the owner of the pants better. In the first case, the lower boundary of the pants should be above the floor at a distance of 5 mm. In the second case, the same boundary should be placed between the heel of the Shoe and its heel part. Don't forget to make a mark.
2
Lay pants on a flat surface. With chalk, draw two lines. The first cutting line and the second line length of the pants. Stock is about 4-5 cm. Also note the thickness of the material of the pants. After all, the thinner the material, the smaller the stock in the ACC.
3
Next, cut along the bottom line of excess fabric. Treat the open seam using zigzag stitch. Will protocide braid 2 mm above the line of bending.
4
Fold pants, while leaving 2 mm of the braid on the front side. This is necessary in order that the fabric on the pants were not worn out during wear. It is desirable to sweep this operation to facilitate the process of podseleniya legs and Ironing.
5
Hem a pant leg. To ease this process, use adhesive tape. Place it between the hem and the main fabric. Iron with steam. However, remember that duct tape has one drawback. She may come off during washing. Therefore it is better hem the pants manually with a needle and fine threads. It will be more reliable.
6
When finished, smooth out both legs with the nous. Then go over with the iron again before removing this excess skin. I hope that you all get, and you've done even without the help of professionals. So you can be proud of myself. After all knowingly speak: "I Want to do something well, do it yourself!".