You will need
  • To connect front speakers to the radio you will need 6 feet of flexible speaker cable 2x0,75 mm 2 rubber corrugations are 14mm in diameter with a rotation of the outputs by 90 degrees. Without turns, but then it will be necessary to carefully wrap the wires with insulation tape so they do not fray about the edges of the holes that you drill in the front doors, as the manufacturer is not provided in the doors, no wiring.
  • To connect the rear speakers, you will need 11 metres of speaker wire 2x0,75mm. Here can be applied not very flexible cable, suitable even for the ordinary, for home electrics brand of PVA. These wires will lie still during the entire period of operation, so they were not in danger.
In the front door directly under the top hinge closer to the outer skin, make a hole with a diameter of 13mm. The second hole should be drilled at 100mm below when you open the door the wire was turned, not bent over. Then it will last a long time. Try how to house the wire in the door and mark with a marker the area of the wire passing through the corrugation, with a small margin.
At the point of exit from the body and the entrance of the door numatyta 5 layers of adhesive tape.
Wear corrugation and with the help of thin steel wire, tighten the wire in the door. Attention! In order not to damage the insulation necessary uglenite wire to make it easier went. Part of the wire that goes inside the body, cannot be laid under carpets – where the wire can easily be damaged, it must be tied with tape to the total transaction.
Output wire to the location where it will be installed radio. Leave a margin of 30...40 cm, for easy connection (if you need to remove the radio and put the other) and do the same work with the second front door.
The wiring for the rear speakers need to make one Board machine, for example, on the left, driver side. You should always strive to gather the wires in a harness.
Fold the wire in half penalty. One of the ends pull the meter and as such smithite the wires with insulation tape. Place bend cut pliers.
Now I have to put the resulting bundle of wires in the car. To lay better along the sill. For greater reliability, the section of harness that passes across the floor, can be tightened in plastic corrugation for electrical cables. Part of the harness that passes directly over the rear parcel shelf can be mounted with plastic clips.
The section of the harness at the front of the car also lift off the floor and attach with tape to the main wiring, and then output to the same place already plumbed for front speakers. Then to not look for where a wire is, the better their mark immediately. For example, "front right" or abbreviated English FR. The rest: front left FL, rear right RR, rear left - RL. Repeat with the rest of the acoustic wires the same. After that, if wires are the same color with or without stripes along the veins, and not in each pair to distinguish between conventional plus and minus, it is necessary to mark the negative lead.
When the wires are labeled, check the tester for short circuit between cores and in the absence thereof, they can be plugged in to the connector to put the radio in place.
Then check the speakers on compliance of the nominal resistance. Modern stereos to fit speakers with a coil resistance of 4 Ohms. If the device shows a resistance of 3.2-3.6 Ohm, can set up speakers in the prepared location and connect them to the speaker wiring. The main thing - not to reverse the polarity, otherwise the bass will not be enough. Please note that the speaker terminal is not in contact with metal parts of the machine.
When everything is connected, test the system.