You will need
  • key 8;
  • key to 10;
  • key 13;
  • - end head 19;
  • - a chain or rope;
  • - winch or steel pipe;
  • - capacity to drain the oil and coolant.
Instruction
1
Take the key 13 and remove the hood, it will facilitate the task. The first step is to Unscrew the six bolts (three each side).
2
Drain the engine coolant. To do this, substitute a lower radiator hose capacity (8-10 years, better pelvis).
3
Open the valve of the heater, loosen the pinch clamp on the lower radiator hose and disconnect it from the radiator. As soon as will flow out, open the cap on the expansion tank and, if applicable, on the radiator.
4
Drain the oil from the crankcase, replacing the container (3) and unscrewing the plug.
5
Take the key on 10 and Unscrew the three bolts on the air filter and remove the cover. Key 8 remove the four bolts that secure the lower part of the filter to the carb and remove it.
6
Disconnect the choke cable from the carb with a screwdriver, remove the accelerator lever. Loosen the hose clamp and disconnect the fuel hose from the tank to the fuel pump.
7
Remove key for 10 bolts that secure the radiator and then pull it out.
8
Take a socket at 13 and remove the four nuts that secure the muffler to the exhaust manifold. Disconnect from the cylinder head and pump tubes of the heater compartment.
9
Remove the engine attachments – alternator, distributor, starter, removing the last key 13 three bolts – two on top and one below. Disconnect the plug to the oil sensor and coolant sensor.
10
Take a head 19 and an elongated key on the bottom of the car Unscrew the four bolts with which the gearbox is mounted to the motor. Place a support under the transaxle.
11
Disconnect the driveline from the transmission, then from the vehicle body and slide it back to the secondary shaft out of the engine.
12
Unscrew the top nut of fastening of the engine to the cushions on the front beam. Wind the motor with a rope or chain.
13
Take out the motor with a winch or by hand. In the latter case, need elevation near the wheels and the belt or chain, insert the steel pipe 50 mm in diameter, the edges of which protrude beyond the dimensions of the machine at 60-100 cm