Instruction
1
To make a Swan out of the tire with your hands, prepare the bus, chalk for marking trim lines, sharp knife, thick wire to secure parts in position, paint for painting the figures of a Swan. If you have a jigsaw, then the work will go much faster.
2
It's best to work with very worn old tires with almost worn-off tread. Its not only easier to cut, but easier to paint. Clean car tyre from dirt, wash it if necessary and dry thoroughly.
3
Mark with chalk cut lines. On the wheel, draw a Swan's neck with a sharp beak and tail in the form of checkboxes, area or fence. To the neck of the bird was quite long, it must pass through half the tire. On the lateral surface of the draw cut lines of the wings. They should have a size of from one-half to two-thirds of the tire.
4
With a knife or jigsaw, cut the neck and tail then the wings of the future Swan. Put the wheel on the end, remove the head and tail out. Spread the wings out to the sides, twisting the rubber.
5
Set the figure on the pedestal of the other tires or Wapiti in the ground. To make a Swan's neck from the tires up high, attach a piece of thick wire tyre, giving it a curved shape. This can be done by using Chomutov to hold the wires and small nails or pieces of rubber and superglue.
6
The wings of a bird, you can make carved, cutting a wide tyre into several pieces and removing of different. Also fairly realistic look to the wings if the edge cut their fence, simulating feathers.
7
Wash thoroughly with soap and water to degrease the Swan, which you do before painting. You can choose any colour from the standard white and black to multicolor. Don't forget to draw the Swan's beak and eyes.
8
If you want to make a Swan out of the original tires, turn on the imagination. For example, you can convert your bird to a Princess, gluing the crown of leftover material.