Instruction
1
For starters make the case for the future of Saba. For this you can use cardboard boxes or pieces of plywood in various sizes. Put your column on the cardboard or plywood and draw around it with a marker all sides of the column.
2
Cut out outlined with the contour of the workpiece to the body.
3
Plywood parts fasten to each other with screws, cardboard details tie at the corners with ropes.
4
Place your column in the resulting body. The gaps between the column and the walls of the shell should not be, otherwise there will be an air bag that can interfere with richness of sound.
5
Remove the column from the housing and saw in it two holes. One front is for the air outlet and the second in the back - for wires, which will be released from the housing. The first hole make size of the loudspeaker column.
6
Create insulation inside the case. To do this, glue it from the inside with insulating material, such as felt. Seal the seams and folds with electrical tape or duct tape.
7
Now again place the column into the case. Attention, now you have to go through a key point in making the subwoofer. Wind the wires from the speakers into a tight beam output through the prepared opening and connect to the acoustics. To do this, find the contacts responsible for the capacity of the column and solder the wires from the resulting subwoofer.
8
If you want to strengthen your a new sub, then integrate inside its housing the amplifier. It is best to fasten it with screws and screwdriver. Don't forget to make the isolation holes.
9
Now paint sub paint of the color that you like best. Look very impressive subwoofers under the "metallic". This is normally conventional paint, for example, "silverfish". SAB ready. If you did everything carefully, in the end you'll have a very decent sound. Place his new acoustic device away from the walls so as not to cause strong vibrations, and not to break sound barriers.
