Advice 1: How to check the oil for Daewoo Nexia

Check the oil level in the engine and transmission at least once a week must get in the habit of every owner of Daewoo Nexia. This will allow you to control the presence of oil in the engine and transmission is not below the minimum mark on the dipstick and see how dirty the oil, and then promptly change it. As a result, the engine of your Daewoo Nexia will last you a long time, and unlikely to be a serious failure.
how to check the oil for Daewoo Nexia
You will need
  • - a piece of clean dry tissue or cloth;
  • rack or pit;
  • - capacity of not less than 3 liters;
  • - socket with "13";
  • special syringe for topping up oil (if it is not, use a medical syringe or a pear to enemas).
Instruction
1
Before you check the oil level in the engine or transmission Daewoo Nexia prepare a piece of clean dry tissue or cloth.
2
Level check engine oil pull out the dipstick and wipe it dry with a prepared cloth. Insert the dipstick back into the hole until it stops and remove it. Now look closely at the oil and make sure it is not excessively dirty, and there are no impurities. Make sure that the oil level on the dipstick is between the "MIN" and "MAX". If the oil level is low refill it.
3
To check the oil level in the gearbox is somewhat more complicated than in the engine, so as constructively to the transaxle Daewoo Nexia is not provided for the dipstick.
4
In order to check the oil level in the transmission, put your car on the trestle, or "the pit". Lock the car using the Parking brake.
5
Clean and dust the surface of the transmission case near the Bay tube and put tube under the Bay, the capacity of not less than 3 liters.
6
Unscrew the cap of the Bay, using a socket to "13".
7
Now insert your finger into the resulting hole. You have to touch the oil surface. Otherwise, the oil level in the gearbox is insufficient.
8
If the oil level is below the edge of holes Bay, then take a special syringe (if it is not suitable medical syringe or pear to enemas) and bring it to the required standards.
9
Repeat the steps in step 7.
10
Allow the excess oil to flow out of holes Bay, then wipe the surface next to it and plug Bay.
11
Screw the plug Bay with a ring spanner on "13".
Useful advice
Try to always maintain the oil level near the mark "MAX", as in the case of unforeseen leak oil you can drive to the nearest service on their own, instead of calling an expensive tow truck.

Advice 2: How to check the engine oil

To check the oil level in the engine regularly, at least 1 time a week, so you do not spend money on costly repairs. Correct podborka type and brand of oil is the key to the smooth operation of the engine.
Check the oil before starting the engine
You will need
  • Dipstick, engine oil, watering can, napkin
Instruction
1
To check the oil level should only to start the engine. You cannot check the oil with the engine running (hazard!), and after turning off the engine. In the first case it is possible to obtain a jet of boiling oil in the face, in the second, boiling oil will not show true level in the engine. To check the level of oil should be on level ground.
2
Near the engine, find the dipstick. Outside, most often it is similar to the plastic handle, however it is a lot like a flattened needle. Gently remove, wipe with a cloth and again lowered into the hole for the dipstick. This is to ensure that the indications were "clean", without considering the tilt of the car. Again take out and look at the mark – notches: max (top, MAX), middle (MID) and minimum (lower, LOW). If the notch is covered with oil level "MAX" or "MID" - all right. If the minimum level – the oil should be topped up.
3
Refill oil better than type, which was covered initially: mineral, synthetic or polysynthetic: "mineral", "semisintetic" and "sintetic", and even better – the same brand. Oil of the same type, but different brands should not mix: motor oil blend can't handle it.
Open the engine cover plug (it has an image similar to a funnel), insert funnel and carefully, trying not to drip oil on the engine topped up with oil. 1-1,5 liters will be enough. Carefully and tightly closed tube. Then again check the dipstick, the oil level and make sure that the level is sufficient.
If still drops of oil was on the engine, you need to carefully wipe with a napkin.
Note
In any case, you cannot use solvent gasoline or other liquids, it's dangerous! All surgeries are best performed in a fabric (not rubber) technical gloves. In case of oil contact with skin – rinse a thick soapy foam.
Useful advice
Check the oil level regularly, at least 1 time a week. This also applies to other liquids. Follow his car, and he faithfully will serve you for a long time.

Advice 3: How to determine the oil level in the engine

The role of motor oils is extremely high. Thanks to them, is the retention of contaminants and oxidation in suspension, they also provide the necessary cleanliness of parts and components of the engine, greatly reduce the degree of wear and tear, take away the excess heat and protect the metal from corrosion.
How to determine the oil level in the engine
Instruction
1
To start I would like to note that the level of oil in the engine of any vehicle should be checked not less than once per week, regardless of weather conditions. This test, first of all, the key to a proper smooth running of your engine and car in General.
2
Prepare to check the engine oil, funnel and cloth. To check you need to take the oil that you poured into your car.
3
Put your car on a flat surface. It is important that when checking the oil machine was not at an angle. Look around the engine dipstick. Usually is a small plastic knob that is on the outside. Look like a small flattened needle.
4
Check the oil level till the start of the motor. In any case it is impossible to determine the oil level when the engine was running, as it is dangerous for your life, you can apolitica a jet of boiling oil, which apparently squirts off the motor. Additionally, you cannot check the engine oil immediately after switching off the power, as in this case it is impossible to accurately determine the fluid level, because it will be in a fluidized state.
5
Remove the dipstick and wipe it carefully with a napkin prepared. Lower back in the hole where he was. This must be done repeatedly to ensure that readings were accurate, because when you drive a car constantly is tilted and, consequently, the oil level is unstable.
6
Remove the needle from the hole and look for marks that it has. Top notch (MAX) – oil level motor max. Average notch (MID) – the oil level is close to half. Lower notch LOW - minimum oil level. If the liquid is at the upper or medium cut-off – all right, you can continue to drive. If the oil level dropped to a lower point – the oil must be topped up.
7
Remember to top up the oil should be of the type that you used initially, that is, if you have been flooded mineral (mineral) oil, refill, it is the same if you had used polysynthetic (semisintetic) or synthetic (sintetic), then it is important to add the same accordingly. In addition it is best to apply each time the oil is the same brand as the engines of the cars are different, and in some cases a mixture of oil the engine can't handle it.
8
If you need to add oil, gently open the tube, which is located on the engine cover, insert it in the hole prepared by the lake, not dripping oil on the engine, pour 1-1,5 liters, and then tightly close the tube, again check using the dipstick, the oil level and wipe clean the engine so it does not remain drops.
9
In the rest of the full quality control of the oils produced in special laboratories according to established procedures in accordance with existing standards. During the test determines the kinematic viscosity at 100 degrees C, flash point, mechanical impurities content, the presence of water, base number, dispersal ability (the ability to retain impurities) and the content of wear elements. When testing must take into account the total operating time of the vehicle during the entire period of operation, its mileage, engine oil consumption, engine failure.
Note
Effectiveness of oils is reduced in the process of operation of the engine in mind altering their chemical properties. So, cease the effect of additives, oxidation of oil, the accumulation of impurities. Change viscosity, base number, etc. When you reach the limits of these indicators of oil is subject to mandatory replacement. It is worth to mention is to determine the quality of the oil on the eyes or the color is almost impossible. For example, in the case of buying a used vehicle specialists definitely recommended to replace the oil to avoid possible trouble.
Search
Is the advice useful?