You will need
  • submersible electric pump;
  • polypropylene pipes of the necessary length;
  • - insulation for pipes;
  • cable electric;
  • - shovel;
  • - the hose.
Instruction
1
Make sure the well is clean drinking water, and there is a real opportunity to connect the well to the house water pipe. In the case of a too distant of the well, will be more economical and effective to dig a new well closer to home.
2
Using spades and shovels, dig a trench of medium depth (40-60 cm, width 20-25 cm) from the house to the well, then take the pipe and check if it would fit to supply water to the house from the well. If the tube is of insufficient length, then you can buy the missing footage and connect the pipe to special pipe.
3
Place the pipe in the excavated trench. One end of the pipe enter the house, and the second enter into a special hole in the wall of the well.
4
When the water pipe will be laid in a trench you can start laying another, smaller diameter pipe that will be used for laying of electric cable. Pass the electrical cable throughout the length of the second tube. Both pipes securely to insulate and protect from freezing in the winter.
5
Take the electric submersible pump and lower it into the well. Connect the special hose pump and water pipe, adjust the height and pressure of water, give the pump a stationary position by means of the additional elements of wire or cable cords. Turn on the pump to the network.
6
You can conduct a trial run of the pump and check its efficiency, if done correctly - from the well to the house to start the flow of water.