Instruction
1
There are several ways of attaching fishing line to the rod. First, determine the length and thickness of line depending on the rod and weight of the expected catch. If you often deal with large fish, but the reliability of the tip is in doubt, further secure the line for the second bend, is equipped with an eyelet. With this method, even if you break the tip of the rod when fighting the fish, the fishing line is still not confused and not lost.
2
In this repeatedly and tightly wrap it around the top of it, and then put on a tight sleeve. If you will not do this efficiently enough, after playing the tip can bend and cut the fishing line from the eyelet to the gum will be very stretched.
3
Most anglers use the method of fixing with a Bobby pin. It is very simple and reliable, but you'll need to install additional detail. Stainless steel spring wire diameter 0.3 mm make pin.
4
Tape it to the tip of the rod of nylon or silk thread and cover with a waterproof varnish. Make sure the tip of the stud snugly to the rod tight and springy. Insure a plastic tube for the pin, pulling it after refueling line.
5
Finish the snap cut thick fishing line, since the pin can be cut at high loads. The resulting limit will not allow the entanglement of the fishing line around the stud.
6
When assembling rods a dull snap wrap fishing line on motoviltse, and then secure it to the tip of the rod vinyl chloride rubber tube. Also you can secure it to the wire loop. So fishing line won't zaselyatsya.
7
The free end of the fishing line along the length from the tip of the rod before the hook can fit the length of the rod or slightly exceed 0.8-1.0 m. If you leave the line of greater length, it can get confused, producing the casting and the fish will be difficult.
8
Modern fishing rods are quite expensive. Be careful, as while fishing, and transportation. And then your passion will bring you a lot of fun and a big catch.