You will need
- - cement-sand mortar;
- - spatula;
- - primer material;
- - drill (malabarista);
- - nozzle-mixer;
- - a needle roller;
- - usually installed with a special strap.
Do a thorough preparation before fabrication of bulk (liquid) floor in the room on their own. It consists of several stages.
Prepare the surface for pouring self-leveling floor. Prepare the necessary tools and acquire the necessary material.
Repaired all the potholes and cracks in the preparatory phase of the cement-sand mortar. to do this, use a spatula. The surface must be dry, since the polymer floor to dry is afraid of water. Its components able to join her in response.
Check the building level horizontal floor. If it does not match, align the surface of the cement-sand mortar, i.e. to make the screed. This will significantly reduce the consumption of expensive material.
Treat the prepared surface of the undercoat material at least twice.Prepare the required amount of liquid of the mixture, based on the calculation: at a layer thickness of 1 cm at 1 m floor require 10 kg of dry mix.
Use to prepare the solution using an electric drill equipped with a speed controller and a mixer. Self-leveling floor screed is a cement-based, polymer additives. It can practically spread on their own, creating a smooth and fairly durable surface.
The final stage is a direct application of self-leveling floor on a prepared surface. It will then be perfectly flat and smooth. Pour polymeric composition self-leveling floor surface after it has dried from the soil.
Evenly distribute the polymer composition in the plane of the rule, removing a needle roller emerging air bubbles. Adjust the thickness of the layer of the special plate (from 1 to 7 cm) mounted on the rule.
You need to work indoors at temperature from five to twenty-five degrees. The humidity should be 60%, otherwise the floor will dry long.
Avoid direct sunlight on the polymer floor when dry.