How to assemble the radiator

If you need to assemble the radiator of a new generation of aluminum or bimetal, take one section and twist to lock in its special inner ends of the threaded connection. Take a special rubber gasket and route it to the connection sections.

The second section tightly against the end face to the first through the gasket. Using the radiator key, pull the sections together.

Take the valve Majewski and wrap the thread seal tape. Using the gas key No. 2 install a valve in the upper end of the radiator. In the same way install shtorku cap and end futorki intended for connection of valves. All subsequent sections are connect on the same principle.

Fill the radiator with water from the hose and put it in a dry place on dry newspaper. If within two hours, the radiator will not show signs of leakage compounds in the form of wet spots, so you put him together correctly.

To collect a cast iron radiator, cast iron head section and to the stop screw it in the threaded connection.

Take the camera from the wheels of the car and cutting her along. Spread a threaded coupling for radiators face with chalk and attach to the rubber so that it left a mark for cutting out gaskets. Cut the rubber on the trail, then back off 2 cm and remove the middle. You should have a ring of rubber.

Miss the end of the section, paint the thread and apply the gasket. Apply a strip coat of paint and push it onto the second section. Pull the sections together by a threaded connection. To do this, use the radiator key. All subsequent sections are connect on the same principle.

Wrap the end futorki during the tow thread and cover them with paint. Take the gas key # 2 and refit Hutorok in the ends of the radiator.

Fill the radiator with water from the hose. It is better to use boiling water or very hot water. If you are found leaking, then the radiator is assembled correctly.