How to mount a wall panel for kitchen

Modern renovation – a wide choice of finishing materials used in the decoration of different rooms. There are many materials with which to decorate the walls of your home, and one of them is a wall panel. These panels will be a good solution to finish the kitchen as they are easy to maintain, they are easy to clean and are durable. Mounted on the kitchen wall panels is easy – it is mounted a wooden frame.

You will need

• - drill;
• roulette;
• level;
• - galvanized screws;
• - dowels;
• - a hammer.

Instruction

1. Calculate the number of panels, not to be mistaken – divide the length of the kitchen wall at the width of the panels. As a result, you will receive a number of panels that need to close one wall.
2. If the wall has a window or a doorway, measure its area and subtract this figure from the length of the wall. Also purchase accessories – corners and profiles for mounting panels in corners and doorways.
3. After the plastic panel will meet in the kitchen at least 12 hours, unpack them and prepare strips of wood to make the frame of the crates. Mark the wall and secure to the ground rods with dowels and screws, observing the distance between the rails in 50-60 cm
4. Place the slats horizontally, parallel to the floor and check the levelness with a level. If you want to fix the facing panels are not vertically but horizontally, install the slats of the crates in an upright position. The crate should always be perpendicular to the direction of the panels.
5. Before you set for fixed purlin PVC panels, process Reiki is a special protective impregnation, so that they do not deteriorate under the influence of humid air. Then install the corner profiles for the installation of the panels and begin to install the panels, starting from the left inner corner, moving to the window or door.
6. Insert the first panel into the groove of the area and its retaining edge set on wooden battens with staples. The second panel will clip in the groove of the first panel and fasten its mounting edge on the crate. Continue to pin the remaining panels similar to the first two. Check the verticality of the panels using a level.
7. The last panel insert the edge in the groove area, closing the connection. Once the kitchen walls are completely covered with panels install skirting between walls and floors.