You will need
  • respirator;
  • protection sunglasses;
  • - gloves;
  • - spatula;
  • - chisel;
  • - a hard brush;
  • - abrasive cloth;
  • - electric dryer construction;
  • - blowtorch;
  • - grinder;
  • - remover;
  • - a solution of vinegar;
  • - solvent.
Instruction
1
Hammer chisel thick layers of oil paint. Chipping should be small pieces of 2-3 mm. It is a time-consuming process, so in large areas it is more expedient to combine different ways. Using concrete and brick walls, the hard disk sander with showerheads, you will save your time and effort.If after this treatment left untreated plots, can be applied chemical method. Take care to protect the respiratory system of the eyes and skin when using toxic substances. Wear a respirator, goggles and gloves, open the Windows. Apply with a brush a wash to the surface and wait 10-15 minutes. The old paint is soft and easily removed with a spatula.
2
Use the thermal cleaning method. Oil paint under the influence of heat starts to melt and burn. Alternately apply heat to areas of the wall with a blowtorch or a Hairdryer and then with a spatula, scrape the sticky mass. This method is good to use on wooden surfaces.
3
Remove latex paint from small areas. If it is PVA based, it is easily destroyed by moisture. Soak the surface with hot water and scrub with a stiff brush. If latex paint produced on the basis of a durable acrylic resin - usablity her statelem or chisel.To clean the walls or ceiling, use the sander and sandpaper (grain 40, 60, 80). To remove chalk paints and glue, use a spatula.Starting from the ceiling, soak the wall with hot water using a brush. Carefully clean off wet paint with a spatula, removing the peeled layer. If it does not respond, DAB a solution of vinegar (3 %). Flatten irregularities on the surface of walls and ceiling, and proceed to the next stages of repair.